河南渑池地区铝土矿工艺矿物学及锂的赋存状态研究

通过河南省渑池地区含锂铝土矿(岩)层工艺矿物学分析,查明铝土矿的物质组成、嵌布特征、伴生锂分布特征和赋存状态,为矿产综合利用提供理论依据。结果显示:该铝土矿Al2O3含量为54.8%,铝硅比值(A/S)为2.6,铝土矿层和粘土岩层中Li2O含量均高于伴生锂边界品位,粘土岩中锂更为富集；矿物组成除一水硬铝石之外,主要是以集合体形态产出的粘土矿物。采用稀酸解析、选矿测试和电子探针分析锂的赋存状态,查明矿石中锂主要是以类质同象置换形式赋存在伊利石和高岭石等粘土矿物中；选矿富锂尾矿中Li2O可富集到0.57%左右,是锂综合回收利用的重点研究对象。      

Passive micromixer with baffles distributed on both sides of microchannels based on the Koch fractal principle

Since the beginning of the 21st Century, the development of microfluidic chip technology has been very rapid and has attracted the attention of more and more scholars. As an important part of the microfluidic chip, the performance of the micromixer is critical. The fractal structure in the microchannels helps to improve the mixing performance of the micromixer and improve the mixing efficiency of the micromixer. The research results of other scholars are of great significance to the research of the present paper, which mainly studies the effect of changing the baffle state on the mixing efficiency of the micromixer based on the Koch fractal principle. Through simulation analysis, it was found that the mixing efficiency of the baffles distributed on both sides of the microchannel was higher than the mixing efficiency of the baffles distributed on the microchannel side. When the distance between adjacent baffles was divided into 0.15, 0.25 and 0.35 mm, simulated data suggested that the baffle distance of 0.15 mm was best. Increasing the number of baffles from six to eight groups increased the mixing path of the fluid in the microchannel and improved mixing efficiency. A comparison of mixing efficiencies of the 0°, 15° and 30° baffle angles revealed that very significant improvement in mixing efficiency was obtained at 30°. © 2019 Society of Chemical Industry     

中医药临床研究电子数据管理特点及标准操作规程的制定

电子数据管理具有节约成本、缩短研发周期、提高数据质量等优势,已逐步成为临床研究数据采集与管理的主流形式,规范开展电子数据管理工作是提高中医药临床研究质量的重要措施。本文介绍了临床研究电子数据管理标准操作规程(standard operating procedure, SOP)的作用、制定原则、一般体例、制定流程、SOP的管理与培训以及实际工作中常用的SOP,最后讨论了中医药临床研究电子数据管理的特点及难点,并给出了建议的解决措施。     

平板集热器(倾角)变化工况数值模拟

运用FLUENT数值模拟软件分析了平板集热器(倾角)变化对集热器传热特性的影响,保证其结构参数不变,通过对5组不同倾角(0°、30°、45°、60°、75°)的数值模型进行非稳态模拟,对模拟数据进行分析,得出了平板集热器不同倾角对集热器传热性能变化的影响。     

A new numerical algorithm to check the observability and bad-data processing ability of the metering scheme

This paper provides a unified approach for the optimization of measurements placements employed for power system online monitoring through state estimation. The proposed methodology, which can be suitable for the mixed measure system, preserves state estimation observability and bad-data processing capability by employing numerical algorithms for observability checking, critical measurements and critical couple identification. First, node injection radix measurements and measurement categories are defined. According to the above definitions, the coefficient matrix can be solved. The analysis on the column vectors of the coefficient matrix can determine each measurement classification. Furthermore, the numbers of each measurement class contains can determine bad-data processing capability. The observability can be checked by the type number of measurements. The proposed method is illustrated with the IEEE39-bus system and the IEEE118-bus system. Results from the case studies are presented to demonstrate that the approach adequately fulfills the desired properties related to observability, bad-data processing, cost, and robustness.     

Coil‐Type Asymmetric Supercapacitor Electrical Cables

Cable‐shaped supercapacitors (SCs) have recently aroused significant attention due to their attractive properties such as small size, lightweight, and bendability. Current cable‐shaped SCs have symmetric device configuration. However, if an asymmetric design is used in cable‐shaped supercapacitors, they would become more attractive due to broader cell operation voltages, which results in higher energy densities. Here, a novel coil‐type asymmetric supercapacitor electrical cable (CASEC) is reported with enhanced cell operation voltage and extraordinary mechanical‐electrochemical stability. The CASECs show excellent charge–discharge profiles, extraordinary rate capability (95.4%), high energy density (0.85 mWh cm⁻³), remarkable flexibility and bendability, and superior bending cycle stability (≈93.0% after 4000 cycles at different bending states). In addition, the CASECs not only exhibit the capability to store energy but also to transmit electricity simultaneously and independently. The integrated electrical conduction and storage capability of CASECS offer many potential applications in solar energy storage and electronic gadgets.     

A distributed state estimation method for power systems incorporating linear and nonlinear models

High-voltage transmission networks are commonly equipped with phasor measurement units (PMU), and some of them are PMU observable. However, PMUs are seldom installed in distribution networks due to budget limitations. The state estimation equations of PMU observable areas are linear, while those of other areas remain nonlinear. This paper proposes a new distributed state estimation method for solving multi-area state estimation problems, in which linear models are used for high-voltage transmission network, while nonlinear models are adopted for other areas. In PMU observable area, we select coordinating variables as generalized cost functions which accurately represent the sensitivity between the linear SE objective function and boundary states. Consequently, SE results identical to a centralized estimator can be obtained without iterations at the coordination level. This paper presents the problem model and theoretical analysis of the proposed method, and shows its effectiveness by numerical tests.     

A new reverse reduce-error ensemble pruning algorithm

Although greedy algorithms possess high efficiency, they often receive suboptimal solutions of the ensemble pruning problem, since their exploration areas are limited in large extent. And another marked defect of almost all the currently existing ensemble pruning algorithms, including greedy ones, consists in: they simply abandon all of the classifiers which fail in the competition of ensemble selection, causing a considerable waste of useful resources and information. Inspired by these observations, an interesting greedy Reverse Reduce-Error (RRE) pruning algorithm incorporated with the operation of subtraction is proposed in this work. The RRE algorithm makes the best of the defeated candidate networks in a way that, the Worst Single Model (WSM) is chosen, and then, its votes are subtracted from the votes made by those selected components within the pruned ensemble. The reason is because, for most cases, the WSM might make mistakes in its estimation for the test samples. And, different from the classical RE, the near-optimal solution is produced based on the pruned error of all the available sequential subensembles. Besides, the backfitting step of RE algorithm is replaced with the selection step of a WSM in RRE. Moreover, the problem of ties might be solved more naturally with RRE. Finally, soft voting approach is employed in the testing to RRE algorithm. The performances of RE and RRE algorithms, and two baseline methods, i.e., the method which selects the Best Single Model (BSM) in the initial ensemble, and the method which retains all member networks of the initial ensemble (ALL), are evaluated on seven benchmark classification tasks under different initial ensemble setups. The results of the empirical investigation show the superiority of RRE over the other three ensemble pruning algorithms.     

Photochemical Reactions in Supramolecular Assemblies of Gels: Dimerizations and Polymerizations via Pericyclic Reactions

Gel state reactions offer new direction for the reactivity of the organic molecules or metal‐organic materials upon photoirradiation with shorter reaction times and high yields compared to solid and solution states. The restricted molecular movement among the molecules in the soft solids control the stereoselectivity of the photoproducts in the gel state reactions. To date, most of the strategies based on self‐assembly have been demonstrated in the solid state, in particular for [2+2] reactions of olefins and polymerization reactions of diacetylenes via 1,4 addition. The soft materials are of emerging materials in recent days given their many applicative day‐to‐day aspects. This review gives a glimpse of recent reports on pericyclic reactions in the gel state that are designed based on the self‐assembly concept. Also it highlights how such reactions accompany the physical changes in the structure of the gels and stereo controlled products with high yields.